Search found 3 matches
- Mon Sep 21, 2015 8:27 pm
- Forum: Roadmap and Feature Request
- Topic: BCS 4.0.0 firmware released
- Replies: 21
- Views: 92662
Re: BCS 4.0.0 firmware released
Just planning an Brett Saison for sometime this week. I will have to flash this over tomorrow to check it out.
- Thu Feb 26, 2015 4:00 pm
- Forum: Wiring, Electrical, Relays and Sensors
- Topic: e-herms elements
- Replies: 6
- Views: 9044
Re: e-herms elements
I went with the Kal style setup with the 2 gang box, drill it out, stick the element through the box and kettle, attatch with a 1" NPS nut. I also soldered the box to the kettle for a good ground. Its a little bulky but it is also solid and watertight in case of accidental boil overs. The only ...
- Thu Feb 26, 2015 3:17 pm
- Forum: Roadmap and Feature Request
- Topic: BCS 4.0 - Anyone using PID with electric elements?
- Replies: 4
- Views: 6495
Re: BCS 4.0 - Anyone using PID with electric elements?
I did notice that on my last brew but it kicked back on. I did notice when I had my auber PID panel it would shut off about 15 degrees low for about 15 seconds and then start the PID cycling to bring it up to the setpoint.