Setting up public access for Mac?

[nuke314]

Can any one post how to set up the public access point? I tried to follow the wiki page instructions but it did not work for me. Any help would be great. Thanks.

[np0x]

Which wiki instructions did you follow? Are you talking about the observer password? or is this the more difficult question of how to poke a hole in your firewalls so people from the outside can see your bcs?

[nuke314]

The second one. I spent a couple hours trying to follow the instructions below, with no luck. was hoping to get some info on this. I sooo want to show this system off.

http://www.embeddedcontrolconcepts.com/ ... g_Remotely

[np0x]

You found the right page, you need to setup your router to port forward a high port(like 8080 or 8000) to the port 80 of your bcs's ip address(e.g. 192.168.1.200) on your private network. This is neither a mac or a pc thing, more of a linksys/dlink kinda thing.