Search found 6 matches
- Sun Jan 11, 2015 7:02 pm
- Forum: Troubleshooting and Support
- Topic: Can someone post their Settings for PID control and wavefor?
- Replies: 3
- Views: 3391
Re: Can someone post their Settings for PID control and wave
Thanks for posting. I was having a real hard time getting my PID output to work (I have a handheld scope). What I ended up doing was: 1. Create a new process with one state 2. First do direct control of the output so I could make sure it turned on and off which it did. 3. Enable duty cycle mode and ...
- Fri Jan 09, 2015 12:18 pm
- Forum: Troubleshooting and Support
- Topic: Can someone post their Settings for PID control and wavefor?
- Replies: 3
- Views: 3391
Can someone post their Settings for PID control and wavefor?
I am trying to get my PID control working and it would be great to see someone else's setting along with the waveform.
- Thu Jan 08, 2015 7:29 pm
- Forum: Troubleshooting and Support
- Topic: Trying to direct connect to a Macbook with no luck
- Replies: 12
- Views: 8190
Re: Trying to direct connect to a Macbook with no luck
I gave up and just connected it to my router which works and I can now connect to it. Seems like this is really the easiest way to connect.
- Sun Dec 14, 2014 2:16 pm
- Forum: Troubleshooting and Support
- Topic: Trying to direct connect to a Macbook with no luck
- Replies: 12
- Views: 8190
Trying to direct connect to a Macbook with no luck
I am trying to direct connect to my Macbook. I have followed the various instructions but nothing seems to work. Has anyone actually been able to make this work and if so, could they go through the steps they used?
- Mon Sep 29, 2014 7:46 pm
- Forum: General Discussion
- Topic: Welcome to the ECC Forum
- Replies: 6
- Views: 21430
Re: Welcome to the ECC Forum
Welcome GeekSpirits! Yes, the web interface is embedded into the BCS, so you need to point your browser to one in order to check it out. You can see one online at http://demo.embeddedcc.com . Also take a look at this thread for the new 4.0 release that is just being finished up: http://forum.embedd...
- Mon Sep 29, 2014 7:05 am
- Forum: General Discussion
- Topic: Welcome to the ECC Forum
- Replies: 6
- Views: 21430
Re: Welcome to the ECC Forum
I just started looking at using the BCS-460 for automating my distillery. The system seems to be reasonably priced and supports adequate I/O capability for what I need (worst case, I would do two systems). One thing I am still struggling with is with the whole interface thing. It looks like it is a ...