Search found 6 matches

by GeekSpirits
Sun Jan 11, 2015 7:02 pm
Forum: Troubleshooting and Support
Topic: Can someone post their Settings for PID control and wavefor?
Replies: 3
Views: 3341

Re: Can someone post their Settings for PID control and wave

Thanks for posting. I was having a real hard time getting my PID output to work (I have a handheld scope). What I ended up doing was: 1. Create a new process with one state 2. First do direct control of the output so I could make sure it turned on and off which it did. 3. Enable duty cycle mode and ...
by GeekSpirits
Fri Jan 09, 2015 12:18 pm
Forum: Troubleshooting and Support
Topic: Can someone post their Settings for PID control and wavefor?
Replies: 3
Views: 3341

Can someone post their Settings for PID control and wavefor?

I am trying to get my PID control working and it would be great to see someone else's setting along with the waveform.
by GeekSpirits
Thu Jan 08, 2015 7:29 pm
Forum: Troubleshooting and Support
Topic: Trying to direct connect to a Macbook with no luck
Replies: 12
Views: 7999

Re: Trying to direct connect to a Macbook with no luck

I gave up and just connected it to my router which works and I can now connect to it. Seems like this is really the easiest way to connect.
by GeekSpirits
Sun Dec 14, 2014 2:16 pm
Forum: Troubleshooting and Support
Topic: Trying to direct connect to a Macbook with no luck
Replies: 12
Views: 7999

Trying to direct connect to a Macbook with no luck

I am trying to direct connect to my Macbook. I have followed the various instructions but nothing seems to work. Has anyone actually been able to make this work and if so, could they go through the steps they used?
by GeekSpirits
Mon Sep 29, 2014 7:46 pm
Forum: General Discussion
Topic: Welcome to the ECC Forum
Replies: 6
Views: 17281

Re: Welcome to the ECC Forum

Welcome GeekSpirits! Yes, the web interface is embedded into the BCS, so you need to point your browser to one in order to check it out. You can see one online at http://demo.embeddedcc.com . Also take a look at this thread for the new 4.0 release that is just being finished up: http://forum.embedd...
by GeekSpirits
Mon Sep 29, 2014 7:05 am
Forum: General Discussion
Topic: Welcome to the ECC Forum
Replies: 6
Views: 17281

Re: Welcome to the ECC Forum

I just started looking at using the BCS-460 for automating my distillery. The system seems to be reasonably priced and supports adequate I/O capability for what I need (worst case, I would do two systems). One thing I am still struggling with is with the whole interface thing. It looks like it is a ...