Yes, looking hard at 4. But I have a lot of development into 3.7.1.
In 4, are my saved processes able to be uploaded? Does it use a different format?
Also, if I go to 4, is there a way to go back to 3.7.1 if I don't like it.
Search found 5 matches
- Thu Oct 29, 2015 4:02 pm
- Forum: Wiring, Electrical, Relays and Sensors
- Topic: Parallel connection of outputs
- Replies: 6
- Views: 3828
- Thu Oct 29, 2015 3:05 pm
- Forum: Wiring, Electrical, Relays and Sensors
- Topic: Parallel connection of outputs
- Replies: 6
- Views: 3828
Re: Parallel connection of outputs
Two different temp probes- one in the brew pot, one in the freezer for fermentation. One ssr for either the chill water pump feeding the HE on the brew pot, or the freezer for the fermenter. I think you can only assign one temp probe per output? It's no big deal using isolation output diodes.
- Thu Oct 29, 2015 12:21 pm
- Forum: Wiring, Electrical, Relays and Sensors
- Topic: Parallel connection of outputs
- Replies: 6
- Views: 3828
Parallel connection of outputs
Can the BCS-460 outputs be connected in parallel to drive the same load? Do I need to install isolating diodes on each output connected in parallel?
- Fri May 29, 2015 6:22 pm
- Forum: Show me your PID
- Topic: Here is my PID (work in progress)
- Replies: 10
- Views: 51456
Re: Here is my PID (work in progress)
Thank you, that is helpful.
- Thu May 28, 2015 4:22 pm
- Forum: Show me your PID
- Topic: Here is my PID (work in progress)
- Replies: 10
- Views: 51456
Re: Here is my PID (work in progress)
OK, can someone explain what iState is? Its listed in the algorithm, but it is not defined. The PID control scheme is named after its three correcting terms, whose sum constitutes the PID output, a number from 0-100%. pid_output = pTerm + iTerm - dTerm; where pTerm = pGain * err; iTerm = iGain * iSt...