Search found 37 matches
- Mon Mar 12, 2012 7:22 pm
- Forum: Wiring, Electrical, Relays and Sensors
- Topic: CIRCUITLAB
- Replies: 4
- Views: 4077
CIRCUITLAB
Hey Folks, Not sure if you've seen this or not, but you might want to check this out. It's a site for creating wiring diagrams, and sharing them out. Best part is it's all bowser based and free *AND* you can cut an paste into a new diagram. No more having to redo someone else's viso diagram in paint...
- Fri Mar 02, 2012 12:20 am
- Forum: Troubleshooting and Support
- Topic: 3.4.6 Spawn Logger not working
- Replies: 2
- Views: 2538
Re: 3.4.6 Spawn Logger not working
Temp0 and Temp1. Both reading flatline. Currently reading feremntation temps and ambient room temps (50-35d).
I don't have any operational outputs as the trigger temp is set for 37d. It's a 460 that was just delivered last week.
I don't have any operational outputs as the trigger temp is set for 37d. It's a 460 that was just delivered last week.
- Fri Mar 02, 2012 12:08 am
- Forum: Wiring, Electrical, Relays and Sensors
- Topic: Toggle switch with 2 led lights
- Replies: 22
- Views: 18371
Re: Toggle switch with 2 led lights
That would be how you'd wire it for the 5 (6v) LEDs. The second +5v powers the LEDs in either the "manual" or "auto" states. I'm pretty sure that the BCS +5v out is switched since it's a common ground, and the presence of voltage is what causes the SSRs to function. If you wanted...
- Mon Feb 27, 2012 2:18 am
- Forum: Wiring, Electrical, Relays and Sensors
- Topic: OK, what do I need??
- Replies: 25
- Views: 26995
Re: OK, what do I need??
Don, Pick a direction, RIMS or HERMS, then you're 50% of the way there. If you're already using a full gas system RIMS will cause you to go partially electric. I personally use HERMS and am quite happy with it. I recirc my mash through a coil in my HLT back into my MT, and use the 460 to control the...
- Mon Feb 27, 2012 1:47 am
- Forum: Troubleshooting and Support
- Topic: 3.4.6 Spawn Logger not working
- Replies: 2
- Views: 2538
3.4.6 Spawn Logger not working
Regarless of the settings. in IE 9, when I spawn a new logger in an additionaly window it continues to report the readings at the time of spawn regardless of changes. This issue has been confirmed on multiple computer systems.
Edit. Same issue with latest version of Chrome.
Edit. Same issue with latest version of Chrome.
- Mon Feb 27, 2012 1:44 am
- Forum: General Discussion
- Topic: low pressure vs high pressure
- Replies: 2
- Views: 4473
Re: low pressure vs high pressure
This is probably a question better suited to a different forum as it's not a BCS issue. That being said, you need a low pressure regurlator that can handle the total BTU output of all your burners on the same feed simultaneously.
Something I've learned the hard way.
Something I've learned the hard way.
- Mon Feb 27, 2012 1:27 am
- Forum: Troubleshooting and Support
- Topic: Displaying negative temps on Data Log page
- Replies: 3
- Views: 3184
Re: Displaying negative temps on Data Log page
Celscius or...?