ECC Forum

Ok, on step 8. Code entry type, am I supposed to copy and paste the code that you wrote in that space?

Wow, thank you so much! I just got an Alexa... as soon as I figure all this out will be super happy!!

I finally did get this to work, though I dont really know why. After some restarts it seemed to work. Very frustrating to say the least.
I couldnt get IE to work at all, so stuck with Chrome. I didnt try FF.

after wasting 2 hours trying to adj set point, I just gave up. another wasted day
tried to adj everything, reset everything... nada... no way to adj set point, it just comes on and stays on.

I should mention I updated successfully in Feb to latest firmware...

4th time I am using this, and for some reason now when I go to adj mash temp set point, its simply not there?? I click on Mash button and element turns on and just stays on, no SP in dial either its just 100% on. restarted BCS couple times... same thing, then when I go to process editor and try to c...

I agree, I set my gauge and thermapen to 150 and now both are dead on, verified here at work. I re ran my test the other day and at 150 with the defaults I was right on, water still boils at 207 but I guess it really doesnt matter, I already know im accurate at 150 which is where it matters. Strange...

ok when I run the ulitity and get the ABC do i use those numbers as is?

{"name":"Temp Probe 0","temp":1548,"setpoint":1550,"resistance":1862,"enabled":true,"coefficients":[0.0011371549,0.0002325949,9.5400029999e-8]}

temp is currently 155 per the gauge and thermapen

Hmmm ok went back to put in the numbers provided. Now my temp readings are about 10 points high per my gauge and thermapen?? I read through the calibrate page... not exactly sure where I should be taking the resistance readings... going to revert back to the original readings... they were much closer.