New update wont work

[artguy]

so I recently updated to the new firmware, saved my process and system files, then uploaded them after the update. Everything went smoothly, until I tried a process as a test. The process button would light up but the output light would not nor would the output light on the hmi display. The brew station did not respond either. No relays would work or turn on and the all stop button would not turn off the process, I had to click the process again to get it to stop. I reverted back to the previous firmware, uploaded all my processes and system files and everything works again. Any thoughts?

[brahn]

I'm not sure what would cause this. I haven't seen any issues like that in the testing that I've done with running processes and outputs. Did the configurations load successfully? Did you go to the Edit Processes page and make sure that it was populated correctly after you loaded the settings?