Jon,
Looks like you had a similar issue back in 2011....of course that was a different Version......but any ideas ?
****
Re: 7-segment displays
Postby JonW on Wed Sep 28, 2011 1:04 am
Currently having issues with the 7 segment displays. They power up just fine and go through their self test, but they are not seeing communication from the BCS. The addresses have been set and the BCS has been enabled for them, but still nothing!
*****
Wire external 7 digit display
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: Wire external 7 digit display
The next message in that thread said that upgrading to 3.4.5 fixed the problem. If you really want to eliminate 3.7.1 as a potential problem, put 3.4.5 on your BCS. That was always my go-to version when I would test stuff.
Re: Wire external 7 digit display
Version 3.4.5 no longer appears to have the firmware files available on wiki.
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: Wire external 7 digit display
I just e-mailed it to you.
Re: Wire external 7 digit display
I flashed to 3.4.5......and the 7seg is still acting the same.
Start up seems normal
v 6.6.2
addr: 2a
display 0 "enabled" in BCS...and applied
I've also reset the controller for good measure
Triple checked all wiring including the ground from v- to BCS GND to 7seg GND
....default led is still flashing that it is not getting any data
Screen on 7 seg is dark
any other suggestions?
Start up seems normal
v 6.6.2
addr: 2a
display 0 "enabled" in BCS...and applied
I've also reset the controller for good measure
Triple checked all wiring including the ground from v- to BCS GND to 7seg GND
....default led is still flashing that it is not getting any data
Screen on 7 seg is dark
any other suggestions?
Re: Wire external 7 digit display
What was the ultimate resolution to this issue? I'm currently looking at a similar set of presenting symptoms.Pilzner wrote:I flashed to 3.4.5......and the 7seg is still acting the same.
Start up seems normal
v 6.6.2
addr: 2a
display 0 "enabled" in BCS...and applied
I've also reset the controller for good measure
Triple checked all wiring including the ground from v- to BCS GND to 7seg GND
....default led is still flashing that it is not getting any data
Screen on 7 seg is dark
any other suggestions?