Wire external 7 digit display

[Pilzner]

Ok....I guess that makes me feel better....
One last question....
I don't seem to be able to get the display to change from one temp setting to another.....In other words, If I change it from Temp 1 to Temp 2 , the display does not appear to be updating.
Thoughts?

[brahn]

You're hitting Apply? I don't think I've seen that, but you could try resetting the BCS.

[Pilzner]

You're hitting Apply? I don't think I've seen that, but you could try resetting the BCS.

Yes.
I've reset, I've done a full power down of both segment and BCS.....nada

7 seg does show power up display, so I know it's working.....default light is also still flashing

[brahn]

I can't look at mine right now, but I thought flashing is bad on the debug light. Do you have more than one LED display hooked up?

[Pilzner]

I can't look at mine right now, but I thought flashing is bad on the debug light. Do you have more than one LED display hooked up?

I only have one display.
Flashing debug means connected properly but not receiving data

[brahn]

Can you post a screenshot of the config?

[Pilzner]

[img]Screen%20Shot%202014-06-13%20at%206.56.52%20PM.png[/img]

[Pilzner]

I tested by changing it to the 2b connection....but still nothing

[brahn]

I assume you also updated the LED to address 2b. That configuration should work fine, I've tested lots of similar configs. None of the wiring came loose?

[Pilzner]

I did change address on display board as well to 2b.
I've checked the wires 10 times. It's driving me nuts.
It seems like a communication issue since the debug led is blinking.....but would that be the board or the BCS?
Is there any way to see what EXP1 and EXP0 are sending as signals?