Can't Apply Settings in any "state" above zero

[ranger9913]

Hello,

Just received my BCS and it's awesome. I can't wait to get this thing running on a brew day. I have been going over my brew day configs and I can seem to get any of my data input to save after hitting apply in any state that is not state 0, any advice?

I noticed this guy had the same problem but it doesn't say if and how he resolved it.http://www.homebrewtalk.com/f51/bcs-460 ... ost1927544

I am using Mac OSX10.6 directly connected to the BCS

[ECC]

I believe that he resolved his problem by updating Firefox:
http://forum.embeddedcontrolconcepts.co ... .php?t=217

[timweber]

Actually I never did solve the problem, I just switched computers since I have two laptops. Firefox version on both computers was the same.

[ECC]

I finally found the root cause of this problem. Its fixed in v3.0 and later.