I last used the system between Christmas and New Years and everything worked fine. Went to pull up the webpage today and no luck. Used FING to confirm TP-Link was active, it was, and said "device down." Went out to the control panel and powered everything down. Waited and turned panel back on. Router comes up ok but no BCS page. Any thoughts? Could the BCS 462 just have gone dead? Seems unlikely.
It is a EBREW 50 Amp panel.
462 not "active"
Re: 462 not "active"
If you are using Powerline adapters try unplugging all adapters (even the ones not plugged into the BCS) from their wall outlets for a few seconds and then plug them back in.
Thomas Brophy
AleForce Homebrewery
AleForce Homebrewery
Re: 462 not "active"
Hardwired the BCS. It appears to be the TPLink router.
Solved for now.
Thanks.
Solved for now.
Thanks.
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: 462 not "active"
It is amazing how many people have had problems here with their TPLink's.391dave wrote:Hardwired the BCS. It appears to be the TPLink router.
Solved for now.
Thanks.
Re: 462 not "active"
I am just going to hardwire now. Heading to the store to get a switch and be done with it.