Timers not working

Get help and insight.
Post Reply
User avatar
Viejo
Posts: 28
Joined: Fri Dec 06, 2013 6:23 pm
Bot?: No

Timers not working

Post by Viejo »

Just had my BCS462 reflashed by the seller after it failed to work properly or update the new firmware, and now everything is working (finally!) except the timers. Below are screen shots of the Process Editor page where I've set up timers for two events in the Sparge/Drain state, and the Main Control page where I show that state active. Timers are stuck on 0:00. What am I missing? These are just examples, but none of the timers in any state actually works.
BCS Process Editor-Timers.jpg
BCS Process Editor-Timers.jpg (194.1 KiB) Viewed 2340 times
Main Control-Timers.jpg
Main Control-Timers.jpg (252.47 KiB) Viewed 2340 times
User avatar
oakbarn
Posts: 846
Joined: Thu Jan 05, 2012 2:28 pm
Bot?: No
Location: Texas
Contact:

Re: Timers not working

Post by oakbarn »

You have the continue check box clicked. The timer must be running from a previous state for the timer to continue. For a State 0, you will almost never have a Continue check box clicked
User avatar
Viejo
Posts: 28
Joined: Fri Dec 06, 2013 6:23 pm
Bot?: No

Re: Timers not working

Post by Viejo »

Thanks, Oakbarn. This is actually State 1, not 0, but you gave me some ideas and it looks like they're working now.
Post Reply