Can't connect to BCS updating 4.0.0 to 4.0.1
Posted: Wed Apr 26, 2017 8:00 am
I was in the process of updating BCS-462 from 4.0.0 to 4.0.1. I followed all instructions from the update thread. Everything seemed to be going great until end of update when the BCS restarted and since could not find it since. The BCS is normally connected via ethernet to a bridge router. The router has a DHCP reservation for the BCS, (192.168.0.10) I have had no problems with finding my bcs in the past. I have tried looking on connected devices within my router, also tried network scanners, i.e. fing. I have tried searching via BCS finder for 4.0. I have tried to hard reset multiple times. holding button for 15, 20, 30, even 60 secs to no avail.
Currently I have the BCS plugged directly into a newly configured router with my computer also connected to the router. My phone and computer are able to be assigned an ip within the DHCP window from this router. The bcs is NO WHERE to be found. I have tried browsing every ip address on this network. (192.168.0.1-192.168.0.254) I have tried reconfiguring my router to 169.254.0.xxx and then connecting bcs and trying to go to its default of 169.254.0.63, nada.
After a 15sec hard reset what version of firmware will the bcs revert? I ask because I was on 4.0.0 and I have been trying to use bcs finder for 4.0. Will the BCS revert back to an earlier version? If so where can I find the BCS finder for 3.x? The wiki for BCS appears to be dead. :/
Currently I have the BCS plugged directly into a newly configured router with my computer also connected to the router. My phone and computer are able to be assigned an ip within the DHCP window from this router. The bcs is NO WHERE to be found. I have tried browsing every ip address on this network. (192.168.0.1-192.168.0.254) I have tried reconfiguring my router to 169.254.0.xxx and then connecting bcs and trying to go to its default of 169.254.0.63, nada.
After a 15sec hard reset what version of firmware will the bcs revert? I ask because I was on 4.0.0 and I have been trying to use bcs finder for 4.0. Will the BCS revert back to an earlier version? If so where can I find the BCS finder for 3.x? The wiki for BCS appears to be dead. :/