BCS-462 dumping all programming

Get help and insight.
dtfeld
Posts: 61
Joined: Thu Oct 27, 2011 7:02 pm
Bot?: No

Re: BCS-462 dumping all programming

Post by dtfeld »

I'm not sure of the spec's but the PWM outputs in an "off"" state showed 50-60 mV between the contact and ground. All others showed 0. Not sure if that helps.
JonW
Site Admin
Posts: 1726
Joined: Sun Jul 18, 2010 7:51 am
Bot?: No
Location: Huntington Beach, CA
Contact:

Re: BCS-462 dumping all programming

Post by JonW »

Any power surges or lightning around? Usually when an output is bad, it's because it was over driven with current. Since you've had a stable system for quite some time though and now all the PWM circuits have gone at once, really makes me think you got hit with some kind of power surge.
dtfeld
Posts: 61
Joined: Thu Oct 27, 2011 7:02 pm
Bot?: No

Re: BCS-462 dumping all programming

Post by dtfeld »

There have been some storms/lightning the past couple of nights, and that is what I suspect. as well.

Are they repairable? Or Am I SOL?

Is there a newer version in the works? I'd love to have a RTD's for temp probes...

DT
dtfeld
Posts: 61
Joined: Thu Oct 27, 2011 7:02 pm
Bot?: No

Re: BCS-462 dumping all programming

Post by dtfeld »

Update:

Brewers Hardware hooked me up with a board with no I2C working for a fair price. I'll install that next week and I should be back up and working.
Post Reply