Page 2 of 2
Re: BCS-462 dumping all programming
Posted: Thu May 04, 2017 7:47 pm
by dtfeld
I'm not sure of the spec's but the PWM outputs in an "off"" state showed 50-60 mV between the contact and ground. All others showed 0. Not sure if that helps.
Re: BCS-462 dumping all programming
Posted: Thu May 04, 2017 9:29 pm
by JonW
Any power surges or lightning around? Usually when an output is bad, it's because it was over driven with current. Since you've had a stable system for quite some time though and now all the PWM circuits have gone at once, really makes me think you got hit with some kind of power surge.
Re: BCS-462 dumping all programming
Posted: Fri May 05, 2017 3:54 am
by dtfeld
There have been some storms/lightning the past couple of nights, and that is what I suspect. as well.
Are they repairable? Or Am I SOL?
Is there a newer version in the works? I'd love to have a RTD's for temp probes...
DT
Re: BCS-462 dumping all programming
Posted: Tue May 09, 2017 2:51 pm
by dtfeld
Update:
Brewers Hardware hooked me up with a board with no I2C working for a fair price. I'll install that next week and I should be back up and working.