BCS-462 Not Functional
Posted: Wed Jun 27, 2018 8:04 am
I run the subject controller for my 4, 7 bbl cellar. I have it configured to communicate directly to my cellar computer via 192.168.0.63. This has worked fine for the past 3 months.
The folowing problems have now shown up and I am not sure to resolve them:
-I can no longer access the controller via 192.168.0.63, however, I stil see flashing lights on the unit at the ethernet port as well as a light on my computer
-The unit no longer appears to be controlling temperature based on the previous setpoints
-In the past, if power was cycled to the unit, the connected loads (pumps via SSRs) would "bump" when the unit powered up. That is to say they would turn on and then off. This no longer occurs when I cycle power.
I have tried restarting my computer and have removed power from the unt for an extended period of time (longer than 5 minutes) and have not realized any changes.
Any advice is very appreciaed.
Chris
The folowing problems have now shown up and I am not sure to resolve them:
-I can no longer access the controller via 192.168.0.63, however, I stil see flashing lights on the unit at the ethernet port as well as a light on my computer
-The unit no longer appears to be controlling temperature based on the previous setpoints
-In the past, if power was cycled to the unit, the connected loads (pumps via SSRs) would "bump" when the unit powered up. That is to say they would turn on and then off. This no longer occurs when I cycle power.
I have tried restarting my computer and have removed power from the unt for an extended period of time (longer than 5 minutes) and have not realized any changes.
Any advice is very appreciaed.
Chris