Sorry if this is obvious and I am missing it......can someone tell me definitively where I can check to verify that I am running the most current version?
Thank you!
Current Software Version
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: Current Software Version
Your firmware version is listed on the "Settings" page of the BCS.
Firmware files are listed here in the forum: https://forum.embeddedcc.com/viewforum.php?f=11
Firmware files are listed here in the forum: https://forum.embeddedcc.com/viewforum.php?f=11
Re: Current Software Version
Thanks, Jon!
Re: Current Software Version
I successfully installed v4.1.2. The question I have is why are all of my temperature probes that are unplugged reading -3276.8? They read correctly when plugged in.
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: Current Software Version
They used to read 0, but that was confusing with those that actually need to display temperatures of 0 (mostly celcius users). It also makes it more obvious when a probe becomes disconnected.
If you have unused temperature inputs, you can disable them on the settings page so they don't display.
If you have unused temperature inputs, you can disable them on the settings page so they don't display.
Re: Current Software Version
Thanks, Jon. I understand that I can disable them. My issue is that I have a few auxiliary probes that are set up for multiple uses and they are unplugged when not in use but must remain enabled.
I run a 2.5 BBL system and use all 8 probes. I have a large TV monitor mounted high on a wall in our brewhouse and cast the BCS interface to it. The temp dials are then large enough to read from a distance. If you ever come up with a method to set the unplugged temp probes to zero please let me know.
I run a 2.5 BBL system and use all 8 probes. I have a large TV monitor mounted high on a wall in our brewhouse and cast the BCS interface to it. The temp dials are then large enough to read from a distance. If you ever come up with a method to set the unplugged temp probes to zero please let me know.