Boil outlets not triggering on BCS-462
Posted: Sat Feb 02, 2019 4:39 am
OK, so I setup the outputs as 4-herms (0-3) and 4-boil (4-7)
From the Main page if I select any of the HERMs buttons, they fire. But not so for the Boil outputs.
These are tied to the BCS on OUT0 and OUT1. There is about 3.8vdc on OUT0 when the Herms fires but nada for the Boil.
Bad unit?
If I move the wire to the Herms all the relays trigger
From the Main page if I select any of the HERMs buttons, they fire. But not so for the Boil outputs.
These are tied to the BCS on OUT0 and OUT1. There is about 3.8vdc on OUT0 when the Herms fires but nada for the Boil.
Bad unit?
If I move the wire to the Herms all the relays trigger