Temp1 with no probes attached is reading 354 F the dial indicator in the software shows about 100F, all the other 3 are reading 0 with no probes hooked up.
Version 4.0.1.
Thanks
BCS460 bad Temp 1 ??
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: BCS460 bad Temp 1 ??
Check your coefficients. Then test it with a probe attached.
Re: BCS460 bad Temp 1 ??
1. Swap probes
If Temp 1 is still high, check coefficients and wiring.
If issue follows probe , probe or wiring on that probe is bad
I have had probes where the heat has ruined the probe wiring just where it goes in the jacket (propane burners).
I now use a heat sleeve
If Temp 1 is still high, check coefficients and wiring.
If issue follows probe , probe or wiring on that probe is bad
I have had probes where the heat has ruined the probe wiring just where it goes in the jacket (propane burners).
I now use a heat sleeve
Re: BCS460 bad Temp 1 ??
Ok, swapped probes, stayed at Temp 1. Swapped wires from temp 1 to temp 2, stayed with temp 1. Checked coefficients and they are the same as the other 3 that are working fine with the same probe. Assuming this channel is fried?