Page 1 of 1
BCS460 bad Temp 1 ??
Posted: Tue Mar 26, 2019 4:43 pm
by Burzurk88
Temp1 with no probes attached is reading 354 F the dial indicator in the software shows about 100F, all the other 3 are reading 0 with no probes hooked up.
Version 4.0.1.
Thanks
Re: BCS460 bad Temp 1 ??
Posted: Tue Mar 26, 2019 4:54 pm
by JonW
Check your coefficients. Then test it with a probe attached.
Re: BCS460 bad Temp 1 ??
Posted: Thu Mar 28, 2019 6:58 am
by oakbarn
1. Swap probes
If Temp 1 is still high, check coefficients and wiring.
If issue follows probe , probe or wiring on that probe is bad
I have had probes where the heat has ruined the probe wiring just where it goes in the jacket (propane burners).
I now use a heat sleeve
Re: BCS460 bad Temp 1 ??
Posted: Mon May 06, 2019 5:28 pm
by Burzurk88
Ok, swapped probes, stayed at Temp 1. Swapped wires from temp 1 to temp 2, stayed with temp 1. Checked coefficients and they are the same as the other 3 that are working fine with the same probe. Assuming this channel is fried?