Stop/Run Processes not Identified
-
- Posts: 29
- Joined: Tue Aug 24, 2010 4:33 am
- Bot?: No
Stop/Run Processes not Identified
When I start one or more processes on the Main Control page I can see the active processes marked with a green dot. When I switch to the Data Log page the processes stay active but the green dots don't activate. Switching to any other page shows the dots again. Updated to software v 3.1 recently. Hope this is something that will be addressed in the next version.
Re: Stop/Run Processes not Identified
Thanks for pointing this out. I think I may have gotten a PM about this awhile back as well. I've updated the v3.1 Errata, it will be fixed in the next rev. Thanks!
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: Stop/Run Processes not Identified
Do you have an ETA for the next rev?
-
- Posts: 29
- Joined: Tue Aug 24, 2010 4:33 am
- Bot?: No
Re: Stop/Run Processes not Identified
Thanks for the rapid response. Another item on the same page. If I have the PID display turned on and switch to any other page from the Data Log page and then switch back, the PID display is turned back off. Is this the proper behavior? It might be nice to have the page return with that setting as it was.
At least these are at the most just minor irritations, nothing that stops getting full use from the BCS-460.
Thanks
At least these are at the most just minor irritations, nothing that stops getting full use from the BCS-460.
Thanks