Ramp Temp not updating on Main Control Page

Get help and insight.
Post Reply
dtfeld
Posts: 61
Joined: Thu Oct 27, 2011 7:02 pm
Bot?: No

Ramp Temp not updating on Main Control Page

Post by dtfeld »

Using the Ramp function in a fermentation chamber and v3.4.5 will not dynamically display the ramp set temp on the main control page without refreshing the page. Is this the way its supposed to be?
ramp setpoint.PNG
ramp setpoint.PNG (23.55 KiB) Viewed 6145 times
gbrewer
Posts: 264
Joined: Wed Feb 11, 2009 8:20 pm
Bot?: No
Contact:

Re: Ramp Temp not updating on Main Control Page

Post by gbrewer »

Confirming the temperature showing in your screen shot of 59.4 degrees under the temperature setpoint is not changing?
dtfeld
Posts: 61
Joined: Thu Oct 27, 2011 7:02 pm
Bot?: No

Re: Ramp Temp not updating on Main Control Page

Post by dtfeld »

Yes...the temp displayed in the lower right hand corner is not updating except if I refresh the entire screen. This is only a display issue as the info on the data log page is accurate.

picky, but I think it should dynamically update.
User avatar
ECC
Posts: 676
Joined: Fri Sep 12, 2008 12:29 pm
Bot?: No
Contact:

Re: Ramp Temp not updating on Main Control Page

Post by ECC »

Agreed, it should probably be dynamic update. I'll add it to the list.
ChuckO2999
Posts: 29
Joined: Tue Aug 24, 2010 4:33 am
Bot?: No

Re: Ramp Temp not updating on Main Control Page

Post by ChuckO2999 »

On a similar problem, on the collect data screen, one of the possible data inputs is the temperature setpoint. Why are these tied to the 4 temperature measurements and not to the setpoints for the 6 outputs? Would be nice to see the setpoint ramp up or down along with the actual temperature.
Post Reply