Would be excellent to also be able to change the Temp Probe associated with the OUT.
I have an element that I would like to heat and maintain with a probe inside the pot but latter switch to a different probe in a line to control the element with a PID
State 0 = Strike = Heat Strike to 166.3
Out 0 = Small HLT Element Temp Probe Association = Temp Probe 4 (Small HLT)
State 1 = HERMS = Maintain HERMS at 153.0
Out 0 = Small HLT Element Temp Probe Association = Temp Probe 1 (MLT AVG)
I know that I could Power the Small HLT Element with a different Out and associated Temp Probe and that is what I plan to do, but PWM Outs are limited. Being able to switch the Probe association in a State would be less $$ and require less wiring.
Alternate PID
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: Alternate PID
In 4.0, you can change the temp probe associated with an output at any state.
See a partial screenshot here: http://forum.embeddedcc.com/viewtopic.p ... t=10#p7896
See a partial screenshot here: http://forum.embeddedcc.com/viewtopic.p ... t=10#p7896
Re: Alternate PID
Yahoo!!!
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: Alternate PID
Bing!oakbarn wrote:Yahoo!!!