ECC Forum

When you try to select a Digital Input as an Exit condition the BCS may hang and not allow you to make a Source TYpe Digital Input (DIN).

If have found that if you select a Temp Probe and set the Value to Zero, THEN select Digital Input, it works fine.

If there is a value other than Zero, It hangs.

How I duplicated the issue.

1. Select Process Editor
2. Select "Keg Clean Process" (any process of your own)
3. Select "Hold" State (any State of your own)
4. Select {Source Type}Temp Probe 0 as exit Condition (any Probe)
5. Select 200 as {Value} (any value other than Zero)
6. Change {Source Type} Digital Input. The BCS Hangs



Work around
1. Select Process Editor
2. Select "Keg Clean Process" (any process of your own)
3. Select "Hold" State (any State of your own)
4. Select {Source Type}Temp Probe 0 as exit Condition (any Probe)
5. Select 0 as {Value}
6. Change {Source Type} Digital Input.
7. Select your DIN => Works fine.

It doesn't appear to me that there is any type of "hang" when this occurs, but rather just that the Source dropdown is not populated with the DIN names.

I'll log it as a bug.