Page 1 of 1
Timer Values with th e Process Display Box
Posted: Sun Aug 07, 2016 9:41 am
by oakbarn
I am not sure, but I thought that the Timer Values were retained in the Process Display Box when you had it set to display "Always" and then killed the Process. It seems in 4.0.1 that they automatically revert to Zero rather than what they were.
- AlwaysTimer.png (18.87 KiB) Viewed 10412 times
Re: Timer Values with th e Process Display Box
Posted: Sun Aug 07, 2016 10:16 am
by JonW
I don't recall if that was a known behavior change between 4.0.0 and 4.0.1. You can always flash 4.0.0 and test it and report back.
Re: Timer Values with th e Process Display Box
Posted: Sun Aug 07, 2016 11:55 am
by oakbarn
Same in 4.0. I would like to request this as it would help in keeping track . The Last Values on Kill would be nice as you could then track them after the fact. The Timers Reset at the Start of a State regardless. While a Process is Running, I know that if a Timer is not used in the Next State, it does retain its value. When I can, I leave my State 7 as "Take Readings" that does basically nothing so I can log the Timers, but sometimes I need all 7 States.
BTW, I had ZERO issues reflashing. I think I finally have it down.