Feature request- clickable HMI
-
BlackTieBrewing
- Posts: 4
- Joined: Sat Feb 18, 2012 3:27 pm
- Bot?: No
Feature request- clickable HMI
It would be great if the lights on the HMI could be used as on/off buttons so that it would be possible to incorporate a valve matrix in the HMI and manually control which valves are open or closed.
-
clearwaterbrewer
- Posts: 383
- Joined: Wed Feb 09, 2011 3:43 pm
- Bot?: No
- Location: Clearwater, FL
- Contact:
Re: Feature request- clickable HMI
or up and down buttons for PID setpoints and more importantly boil power level...
adjusting boil power level is the single most annoying thing that I have noticed.. going in and changing the %power during boil causes it to go 100% for a bit, and has caused a boilover... I can switch my BK H-O-A over to manual and my PWM knob, but at flame-out, I have forgotten to switch it off, and I am cooling and heating at the same time...
adjusting boil power level is the single most annoying thing that I have noticed.. going in and changing the %power during boil causes it to go 100% for a bit, and has caused a boilover... I can switch my BK H-O-A over to manual and my PWM knob, but at flame-out, I have forgotten to switch it off, and I am cooling and heating at the same time...
Re: Feature request- clickable HMI
clearwaterbrewer,
I added some functionality along the lines of what you are wanting I believe.
Check out this thread http://forum.embeddedcc.com/viewtopic.php?f=6&t=777
I added some functionality along the lines of what you are wanting I believe.
Check out this thread http://forum.embeddedcc.com/viewtopic.php?f=6&t=777