My version of the HMI builder

Applications that run on PC/Mac.
User avatar
oakbarn
Posts: 655
Joined: Thu Jan 05, 2012 2:28 pm
Bot?: No
Location: Texas
Contact:

Re: My version of the HMI builder

Post by oakbarn » Thu Aug 17, 2017 5:27 am

punk_rock wrote:
Wed Aug 16, 2017 1:44 pm
bbrally wrote:
Tue Aug 15, 2017 4:27 pm
If this is a valve you manually turn on/off, then the only way currently, would be to assign it an output your system is currently not using and program that output to reflect the change you want.
I did use my last available output for my manual valves. I wish I would have bought the 462. It might be time to upgrade.

Thanks for the reply!
I do not even have enough outs on the 462! I do use one for valves but I have a solid manifold that is kept in place. There are a lot of valves. I am not in front of it but I think I have 23 valves. I also have 9 Temperature Probes so I switch the wire (M12 Disconnect) between 2 probes (one in Mash and then switch to Cooling Water when I am transferring to Fermentor.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest