Open Interface Manual Mode
Posted: Fri Nov 20, 2009 7:10 pm
Hello,
I've begun looking through the documentation for the BCS open interface.
Is there a way to control the BCS via manual mode using the open interface? For example, similar to manual mode on the OEM interface, I would like to control output 1 with an output of 50%. Or say output 3 with a PID temperature setting of 190 degrees.
Thanks,
IBB
I've begun looking through the documentation for the BCS open interface.
Is there a way to control the BCS via manual mode using the open interface? For example, similar to manual mode on the OEM interface, I would like to control output 1 with an output of 50%. Or say output 3 with a PID temperature setting of 190 degrees.
Thanks,
IBB