BSC Fermentation Controller

Post pictures of your System
Post Reply
jward
Posts: 52
Joined: Sun Oct 04, 2009 9:38 pm
Bot?: No

BSC Fermentation Controller

Post by jward » Sun Nov 05, 2017 12:04 pm

Made good progress this weekend building out BCS based fermentation controller.

Image
Image
Image

User avatar
JonW
Site Admin
Posts: 1466
Joined: Sun Jul 18, 2010 7:51 am
Bot?: No
Location: Huntington Beach, CA
Contact:

Re: BSC Fermentation Controller

Post by JonW » Thu Nov 09, 2017 12:29 pm

Looks like you switched over to the Electronics Salon relay module. Is that the same PS you were originally using?

Git 'r done!!!

jward
Posts: 52
Joined: Sun Oct 04, 2009 9:38 pm
Bot?: No

Re: BSC Fermentation Controller

Post by jward » Thu Nov 09, 2017 5:07 pm

That is the Electronics Salon relay, but I think the other one was Electronics Salon too but the DIN version. I was going to go with DIN but decided better of it. It's a different PS. I was going to use the one from a disk drive enclosure but came by this smaller one that only does 12v.

jward
Posts: 52
Joined: Sun Oct 04, 2009 9:38 pm
Bot?: No

Re: BSC Fermentation Controller

Post by jward » Sun Nov 12, 2017 10:11 am

I worked through some grounding issues with the help of JonW (thank you!) adding a connector block for grounding wires:

Image

Here is a photo of the system almost in action. It's setup and running but without an active fermentation my garage is colder then the fermentation would be:

Image

I am also amused that in the photo I can see the red and green colors in the temperature leds. Directly viewing them not so much.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest