Page 1 of 1

BSC Fermentation Controller

Posted: Sun Nov 05, 2017 12:04 pm
by jward
Made good progress this weekend building out BCS based fermentation controller.

Image
Image
Image

Re: BSC Fermentation Controller

Posted: Thu Nov 09, 2017 12:29 pm
by JonW
Looks like you switched over to the Electronics Salon relay module. Is that the same PS you were originally using?

Git 'r done!!!

Re: BSC Fermentation Controller

Posted: Thu Nov 09, 2017 5:07 pm
by jward
That is the Electronics Salon relay, but I think the other one was Electronics Salon too but the DIN version. I was going to go with DIN but decided better of it. It's a different PS. I was going to use the one from a disk drive enclosure but came by this smaller one that only does 12v.

Re: BSC Fermentation Controller

Posted: Sun Nov 12, 2017 10:11 am
by jward
I worked through some grounding issues with the help of JonW (thank you!) adding a connector block for grounding wires:

Image

Here is a photo of the system almost in action. It's setup and running but without an active fermentation my garage is colder then the fermentation would be:

Image

I am also amused that in the photo I can see the red and green colors in the temperature leds. Directly viewing them not so much.