ECC Forum

Posted: **Fri Jan 09, 2015 12:16 am**

Hi

I would like to know what is the maximum possible lenght between temperature probe and the bcs.
My fermentation room is far from my brewing stand (about 50 feet).

Sorry for my bad english

regards

Tonio

Posted: **Fri Jan 09, 2015 8:08 am**

50 feet should be fine. Make sure you have wired a jumper between the BCS ground and the AC (earth) ground. If you don't do this, your temps will fluctuate up and down.

Posted: **Fri Jan 09, 2015 9:52 am**

Thank you for your help.
Do I have to use special wire for that?

Posted: **Fri Jan 09, 2015 10:39 am**

No, not really, but using twisted and/or shielded will only help with noise immunity.

ECC Forum

Maximum lenght between bcs and temp probe

Maximum lenght between bcs and temp probe

Re: Maximum lenght between bcs and temp probe

Re: Maximum lenght between bcs and temp probe

Re: Maximum lenght between bcs and temp probe