Thermo Test page

[thb]

Hi ! Newbie here! Thorshaug Bryggeri/Brewery - Norway
I can´t find the Thermo Test page in the BCS 462 v4.0 ?
The sensors from brewershardware for the BCS displays appro.x 2 C less than our backup analog and digital handheld sensors.
The BCS 462 v4.0 came with : A: 0.0011371549, B: 0.0002325949, C: 9.540002999e-8
on the attached document new values were listed ,but those gave more than 10C wrong in our system.

[JonW]

If you're looking for a coefficient calculator, there is a link in the second post of this thread: http://forum.embeddedcc.com/viewtopic.p ... 666&p=9462

If you have probes from Brewers Hardware, then the base coefficients should be close, but if you have the original probes from ECC, then they will be considerably off.

[BrunDog]

Use a calculator to get your thermistor coefficients correct. Once they are dialed in, they should be very accurate. You need the published temp / resistance pairs. I like:
http://www.thinksrs.com/downloads/progr ... ulator.htm

-BD

[thb]

Thanks!!