Do I have this correct? I am putting a light switch (DPST 30 Amp) in the Circuit prior to the SSR so I can cut the other hot leg when I am not brewing. (In fact all of my elements have this positive cutout even if 110)
I am running #10/2 w GND from an existing dryer Plug to the element, one leg through the SSR.
I plan to use PWM control (P or H) on my new SCORE HLT.
220 v 5500 Watt Element Wiring
Re: 220 v 5500 Watt Element Wiring
After reading some other blogs, I added a Contactor. Any idea if this is correct?
Re: 220 v 5500 Watt Element Wiring
I was making it to complicated. When I was looking at the wiring I wanted to use what I have (10/3 SOOW) and be neat. Since the way I had it would have required 10/2 with ground x 2 to the DPST Wall Switch, I decided that I would just put it before the 40 amp relay and the SSR. that way I can run the 10/3 from the Circuit to the DPST switch, then 10/3 to the Relay. I also decided that the Relay as the safety could also be the control and just have the SSR control the relay with the Transformer being powered at all times. I think this provides a flow so that there is no "hot" to the element if the BCS is not calling for heat ( and making both legs hot with the relay). The DPST is a positive cutoff for when I am not brewing or the HLT is empty. Any comments other than mine????