ECC Forum

Posted: **Mon Dec 18, 2017 7:16 am**

I use a 25 foot XLR mic cable between my BCS panel and my fermenting area. I have several of these that are dedicated for sensors and outputs and they work great. I'm out of XLR ports on my panel...but have spare conductors in some of my temp sensors. Is it ok to run an output and a temp sensor in the same XLR?

Posted: **Mon Dec 18, 2017 9:35 am**

Yes, the outputs are very low voltage and don't interfere with the temp sensors.

Posted: **Mon Dec 18, 2017 10:02 am**

Thanks JonW. That saves me a lot of work. Hopefully I soldered up extra leads on the xlr jacks in my panel.

ECC Forum

Temp sensor and output in same XLR?

Temp sensor and output in same XLR?

Re: Temp sensor and output in same XLR?

Re: Temp sensor and output in same XLR?