Remote 7 seg display?
Remote 7 seg display?
Wondering if it'd be possible to drive a 7 seg display mounted remotely- I'm building out a remote temp controller connected to BCS via cat 5 (temp probe and heat/cool relay signals) and wondering if EXP0/EXP1 for the 7 segment display could also be run thorugh the CAT5 to display current/set temp nearer to the refrigerators... thoughts?
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: Remote 7 seg display?
What is your distance? The I2C bus can be extended with buffer drivers if it is a significant distance.
Re: Remote 7 seg display?
Going to be about 25ft from controller to remote box install.
Re: Remote 7 seg display?
The I2C bus is typically not meant for long distances. Ideally less than 24".
Re: Remote 7 seg display?
Hm. So where do I go to find out more about a buffer driver to extend an I2C cable?
-
- Posts: 70
- Joined: Mon Nov 24, 2014 11:58 am
- Bot?: No
Re: Remote 7 seg display?
I know this thread is several years old, but I'm just now discovering the BCS products, and digging through the forums finding ideas. Yours made a couple light bulbs go off, so I went to google. There's a pre-made product for this as of Nov 2014, though you could also DIY from the controller chips if you prefer:
http://sandboxelectronics.com/?product= ... 715-module - only $17.95.
http://sandboxelectronics.com/?product= ... 715-module - only $17.95.