ECC Forum

I've just started researching brewery automation and looking are sourcing parts on a budget. I was curious if my assumption is correct on being able to partner this board.

http://www.ebay.com/itm/New-16-Channel- ... 27c1368732

I realize I would have to manually wire the input, but at $26 I could do a little soldering, or purchase a separate cable from digi-key.

Thanks
Squeeky

That's a nice looking board for the price. I used this one: http://www.ebay.com/itm/Eight-8-Relay-M ... 3a597608f1

This will be fine for your low voltage valves, but you can't run your pumps or other high voltage devices from it. You'll need SSR's for those.

You better make darn sure that with that relay board a high input makes the relay click, not grounding the input, or you will have a paperweight... I know...

search here for relay boards....

FYI - the Electronics-Salon one above posted by Jon is what I recommend also.. but I do use them for pumps, contactors, etc, they can handle 10A@250VAC