Page 1 of 1

Temp Controller Widget

Posted: Sat Dec 15, 2012 9:58 am
by dtfeld
I thought this was covered, but a while ago...and this may be in another forum. However, I can't find what I'm looking for.

Looking for a Temp Controller widget to replace the standard temp guages on the Main Control Page. Would like to display SV as well as PV and some radio buttons to change the temp would be great. Any body done/seen/herard of this being done? Can you point me the right direction?

Wouldn't think this to difficult, maybe it belongs in the future feature request pile.

Re: Temp Controller Widget

Posted: Sat Dec 15, 2012 11:00 am
by JonW
SV and PV???

Re: Temp Controller Widget

Posted: Thu Feb 07, 2013 4:17 am
by MaxOut
JonW wrote:SV and PV???
Process Value / Setting Value

Actual Temp/Set Temp

Re: Temp Controller Widget

Posted: Thu Feb 07, 2013 8:13 am
by JonW
The current beta version has new digital LED looking temp dislplays that show temps and setpoints.

Re: Temp Controller Widget

Posted: Thu Feb 07, 2013 9:57 am
by brahn
Like JonW said, this feature will be in 3.7.0 when it is released.

dtfeld, you're already part of the Beta Testers group. You should be able to grab the beta firmware and check it out.

Re: Temp Controller Widget

Posted: Tue Feb 19, 2013 6:29 am
by chadillac
Is there an ETA on the new firmware?

Re: Temp Controller Widget

Posted: Wed Feb 20, 2013 4:31 pm
by brahn

Re: Temp Controller Widget

Posted: Sun Apr 21, 2013 9:11 pm
by ksl177
brahn wrote:Like JonW said, this feature will be in 3.7.0 when it is released.

dtfeld, you're already part of the Beta Testers group. You should be able to grab the beta firmware and check it out.
Well, you're half right. ;)

3.7 does have digital indicators that show set point and current temp. There is no same screen way to adjust your set point mid process in 3.7 though.

The closest thing available is here:
http://forum.embeddedcc.com/viewtopic.php?f=6&t=777

Be advised you'll not be able to use the PID style displays if you use the "new analog" thermometers and set point indicators. The Analogs still work 100%, however if you switch to the pid Temp0 shows as a blank circle.