Page 1 of 2

HMI Builder available in 4.0?

Posted: Fri Oct 09, 2015 5:34 pm
by erichter66
Is the HMI builder still available in firmware version 4.0, or is it replaced by the APIs?

Re: HMI Builder available in 4.0?

Posted: Fri Oct 09, 2015 6:58 pm
by JonW
4.0 does not currently have an HMI builder.

Re: HMI Builder available in 4.0?

Posted: Mon Jan 11, 2016 11:07 am
by Wazu_Wazu
Are there any thoughts to adding an HMI builder to 4.0?

Re: HMI Builder available in 4.0?

Posted: Fri Oct 21, 2016 8:05 am
by sunadmn
Bumping this topic since it's been well over a year since the first post and not a lot of chatter here. Will there be an HMI builder interface available in the 4.x firmware?

Re: HMI Builder available in 4.0?

Posted: Mon Nov 28, 2016 12:19 pm
by GORGETDISTILLINGCO
Will there be an HMI builder interface available in the 4.x firmware?

Re: HMI Builder available in 4.0?

Posted: Fri Feb 17, 2017 2:05 pm
by oakbarn

Re: HMI Builder available in 4.0?

Posted: Wed Jul 12, 2017 2:20 pm
by BREWMASON
This is very cool but for fermentation the old HMI was super simple and sweet. Does anyone have the old links to the BCS-462 firmware that used the original HMI. Think it was version 3.7.1? Please let me know. Thank you in advance!!

Re: HMI Builder available in 4.0?

Posted: Sat Jul 22, 2017 6:55 pm
by oakbarn
BREWMASON wrote:
Wed Jul 12, 2017 2:20 pm
This is very cool but for fermentation the old HMI was super simple and sweet. Does anyone have the old links to the BCS-462 firmware that used the original HMI. Think it was version 3.7.1? Please let me know. Thank you in advance!!
look at https://forum.embeddedcc.com/viewtopic. ... are#p11977

Re: HMI Builder available in 4.0?

Posted: Wed Jul 26, 2017 1:09 pm
by BREWMASON
Thank you Oakbarn!!! I just ordered a BCS-462 to work with and try to master the HMI. Really struggled with it on my first attempt on someone else's. I think if I have y own to work with it will make things a lot easier. We just added another three 3bbl fermenters and the PID I replaced on our Perlick 4410 would not drop below 40. Going to test a Powerswitch tail SSR inline with the compressor so I can bring the temp down to 20 and implement some rest periods for the compressor. Playing with some ideas and fiddling with the HMI info you sent me before. Thank you very much!!!

Re: HMI Builder available in 4.0?

Posted: Thu Jul 27, 2017 1:48 pm
by oakbarn
HMI GUI Fermentor2.png
HMI GUI Fermentor2.png (155.44 KiB) Viewed 23559 times
This is a pix of my HMI GUI for my fermentors.