New BCS Config check..
Posted: Thu Mar 06, 2014 3:00 pm
Hey all.. Long time lurker who is embarking on an automated Ferm/Serv/Brew (semi) automated brewing control project. My goal is to have BCS-462 wall mounted away (but close) to BrewSculpture and Ferm+Keezer. I would like to connect everything via CAT-5 where possible. My runs would not be more than 20-30 feet in any one direction. I read on the ECC wiki that one Cat-5 cable would support two SSR's and one Temp sensor.. Based on this I created the diagram that is attached this post.. I'm trying to wrap my head around each component but from a 10,000 foot level I see each unit having its own control/electrical box with electrical supplied locally at each. Only Cat-5 connecting each to the wall mounted BCS control box. Im not sure if Cat-5 should home run from each device back to BCS control box or patch from each to the BCS control box? Anyway this is V1.0 so please share any mistakes or misinterpretations or gross violations you may see... Thanks one and all