I have configure my 12 resistor,4 pumps bcs462. I have test it one function at a time. around 8 month ago I noticed a lot of induce ac noise in my ssr, so I change all ssr to the crydom h12wd4850. this is a 50 amp with a snubber circuit. I noticed that the notice drop to almost zero. now the issue is that the first unit the 5vdc and the output stop working. dont know why. I got it replace with a 300% service satisfaction. Still would like to know what happen. today I turn the unit again to continued programing and testing. The unit has not been is full usage yet . . I have attached a block diagram of the wiring, to see if any one see something improper. the unit still connect to the dsl and I can program it, but no output.
I already bought a new one but need to know what is going on.
charles
help needed
-
- Posts: 42
- Joined: Fri Nov 11, 2011 2:34 am
- Bot?: No
- Location: Puerto Rico
help needed
- Attachments
-
- block diagram.JPG (142.9 KiB) Viewed 3489 times
-
- Posts: 42
- Joined: Fri Nov 11, 2011 2:34 am
- Bot?: No
- Location: Puerto Rico
Re: help needed
it seems we dont have electrical advisors in the forum. Bottom line I found the problem and it was a cross conection from the common to chasis. also the box needed to be ground to source chassis
-
- Posts: 383
- Joined: Wed Feb 09, 2011 3:43 pm
- Bot?: No
- Location: Clearwater, FL
- Contact:
Re: help needed
gyropilot1 wrote:it seems we dont have electrical advisors in the forum. Bottom line I found the problem and it was a cross conection from the common to chasis. also the box needed to be ground to source chassis
we do, but your drawing, to be honest, is difficult to read....
this guy got help right away:
http://forum.embeddedcc.com/viewtopic.php?f=17&t=1633
this guy did:
http://forum.embeddedcc.com/viewtopic.p ... t=+diagram
and this guy:
http://forum.embeddedcc.com/viewtopic.p ... lit=+visio
I use visio,
others use other programs... here is a thread on using google sketchup:
http://forum.embeddedcontrolconcepts.co ... ?f=4&t=184
-mike