Page 1 of 1
Rims tube sensor
Posted: Sat Feb 06, 2016 7:52 pm
by Hitz87
I have a sensor for my rims tube that is 4 degrees off. I d I not know how to adjust it, please help.
Thanks,
David
Re: Rims tube sensor
Posted: Sat Feb 06, 2016 8:33 pm
by JonW
Check out this thread:
http://forum.embeddedcc.com/viewtopic.php?f=6&t=10
Are you using a Brewers hardware probe, an earlier ECC probe or a probe from another source?
Re: Rims tube sensor
Posted: Sun Feb 07, 2016 6:49 am
by Hitz87
I had got the rims tube from Brewers hardware along with the tri clamp probe at the same time.
Re: Rims tube sensor
Posted: Sun Feb 07, 2016 8:58 am
by JonW
How are you determining that it is off by 4 degrees?
Re: Rims tube sensor
Posted: Sun Feb 07, 2016 6:52 pm
by Hitz87
Putting the sensor in with a thermometer in several different water samples and my yeast does not end up going thru the last 3 or 4 gravity points the calculation predicts because my mash temp is always 4 degrees off from what it should be. I just brewed a beer and adjusted my temps accordingly and I hit my estimated FG exactly for the first time since I built this system.
Re: Rims tube sensor
Posted: Tue Feb 09, 2016 6:25 am
by clearwaterbrewer
there is a very prominent sticky in the programming section of this forum.. just follow it and you are all set.