Process & Temp Probe Displaying Twice Under Temp Setpoints

[kgearhardt]

I'm not sure exactly when this started happening, but whenever I go to the Temperature Setpoints page for my BCS-460 I am seeing one of my processes & its temp probe displaying twice in the list. One of the entries is "valid" based on the setpoint being correct and correlating to the main display, and the other is just garbage that I cannot figure out how to get rid of. I have included a screen grab showing exactly what I'm referring to. The FV-1 Control process with the 88°F setpoint is bogus.

I am running firmware 4.0.0 build 5bf883e.

Can anyone offer advice on how to correct? I have reset the unit several times but nothing changes.

Thanks!

[JonW]

Can you post a pic of the config screen for FV-1 Control / Cooling state?

[kgearhardt]

Here you go... FWIW it's the same for all 4 processes (FV-1,2,3,4). Thanks!

[JonW]

I seem to recall this coming up before. Can you update to the latest firmware and test this?

[kgearhardt]

I seem to recall this coming up before. Can you update to the latest firmware and test this?

I will give that a go in a few days after my 2 active fermentations that are being cooled under control of my BCS have settled down... Thanks!

[brahn]

You're running the first public beta release of the 4.0 firmware. There have been a lot of things fixed since that release, specifically this one from the public beta 3 release:

Fixes for the temp setpoint adjust page. fixes #186

I think upgrading to a newer version should resolve this issue.

[kgearhardt]

You're running the first public beta release of the 4.0 firmware. There have been a lot of things fixed since that release, specifically this one from the public beta 3 release:

Fixes for the temp setpoint adjust page. fixes #186

I think upgrading to a newer version should resolve this issue.

Thanks brahn!