BCS 482

Suggestions, Problems, Availability, etc. Everything is up for discussion.
Post Reply
User avatar
oakbarn
Posts: 846
Joined: Thu Jan 05, 2012 2:28 pm
Bot?: No
Location: Texas
Contact:

BCS 482

Post by oakbarn »

Just placed my Order! 8-)
User avatar
oakbarn
Posts: 846
Joined: Thu Jan 05, 2012 2:28 pm
Bot?: No
Location: Texas
Contact:

Re: BCS 482

Post by oakbarn »

Relay Board


https://www.ebay.com/itm/8-DPDT-Signal- ... 1e6c957786

Is this a good board to run CR05 Ball Valves with the BCS 482. I intend to replace some of my manual valves with CR05 12 vdc SS Ball Valves but want to use this to close the valve when the Out is "off".

If I remember JonW suggested leaving the valves open after cleaning and with CR 05, I can do that. :D
JonW
Site Admin
Posts: 1726
Joined: Sun Jul 18, 2010 7:51 am
Bot?: No
Location: Huntington Beach, CA
Contact:

Re: BCS 482

Post by JonW »

Never used that specific board, but looks like it would be fine.

CR05 is the last wiring type I would get for ball valves. I personally have CR02 wiring which works well, but if I were doing something new for the BCS-482, I would use CR03 as you would not even need a relay board to drive them.
Post Reply