Page 1 of 1
BCS 482
Posted: Tue Mar 20, 2018 6:52 am
by oakbarn
Just placed my Order!
Re: BCS 482
Posted: Tue Mar 27, 2018 7:53 am
by oakbarn
Relay Board
https://www.ebay.com/itm/8-DPDT-Signal- ... 1e6c957786
Is this a good board to run CR05 Ball Valves with the BCS 482. I intend to replace some of my manual valves with CR05 12 vdc SS Ball Valves but want to use this to close the valve when the Out is "off".
If I remember JonW suggested leaving the valves open after cleaning and with CR 05, I can do that.
Re: BCS 482
Posted: Tue Mar 27, 2018 9:36 am
by JonW
Never used that specific board, but looks like it would be fine.
CR05 is the last wiring type I would get for ball valves. I personally have CR02 wiring which works well, but if I were doing something new for the BCS-482, I would use CR03 as you would not even need a relay board to drive them.