ECC Forum

Just placed my Order!

Relay Board


https://www.ebay.com/itm/8-DPDT-Signal- ... 1e6c957786

Is this a good board to run CR05 Ball Valves with the BCS 482. I intend to replace some of my manual valves with CR05 12 vdc SS Ball Valves but want to use this to close the valve when the Out is "off".

If I remember JonW suggested leaving the valves open after cleaning and with CR 05, I can do that.

Never used that specific board, but looks like it would be fine.

CR05 is the last wiring type I would get for ball valves. I personally have CR02 wiring which works well, but if I were doing something new for the BCS-482, I would use CR03 as you would not even need a relay board to drive them.