For Windows there are some one-time steps needed to set up a USB Driver for the BCS:
1. Download Zadig
2. Connect the BCS to the PC via USB and use Zadig to select the BCS and install the libusbK drivers.
After the drivers are installed you can use the bcs-dfu utility that is in the attached file:
Run the utility, select the dfu file and press Flash to update the firmware. When flash is complete, unplug USB and power cycle the BCS.
The instructions for Mac are the same as for linux, but to get the dfu-util package we recommend using Homebrew to install dfu-util.
Install the dfu-util package from your distribution and run the command
Code: Select all
dfu-util -D bcs482.dfu