Page 1 of 1

Welcome to the ECC Forum

Posted: Fri Sep 12, 2008 2:00 pm
by admin
Have questions about your BCS Temperature Control System? Suggestions? Post them here so the community can benefit.

Please read the Disclaimer.

Re: Welcome to the ECC Forum

Posted: Tue Oct 14, 2008 5:16 am
by Zulu
Looking forward to learning more.

Re: Welcome to the ECC Forum

Posted: Tue Jan 06, 2009 7:18 am
by ECC
If this is your first time here, introduce yourself! Introductions

Re: Welcome to the ECC Forum

Posted: Mon Sep 29, 2014 7:05 am
by GeekSpirits
I just started looking at using the BCS-460 for automating my distillery. The system seems to be reasonably priced and supports adequate I/O capability for what I need (worst case, I would do two systems). One thing I am still struggling with is with the whole interface thing. It looks like it is a HTML based interface, but I haven't found the webpage where you actually do the interface other than the link to controlling an actual system. Can someone point me to where the base webpage exist for interfacing to the controller (or does it reside on the controller so you need to have one you connect to?).

Thanks !

Re: Welcome to the ECC Forum

Posted: Mon Sep 29, 2014 8:33 am
by JonW
Welcome GeekSpirits!

Yes, the web interface is embedded into the BCS, so you need to point your browser to one in order to check it out. You can see one online at http://demo.embeddedcc.com .

Also take a look at this thread for the new 4.0 release that is just being finished up: http://forum.embeddedcc.com/viewtopic.php?f=11&t=2365
The new release really simplifies the interface and gives it a performance boost as well. The update will work for all existing units.

Re: Welcome to the ECC Forum

Posted: Mon Sep 29, 2014 7:46 pm
by GeekSpirits
JonW wrote:Welcome GeekSpirits!

Yes, the web interface is embedded into the BCS, so you need to point your browser to one in order to check it out. You can see one online at http://demo.embeddedcc.com .

Also take a look at this thread for the new 4.0 release that is just being finished up: http://forum.embeddedcc.com/viewtopic.php?f=11&t=2365
The new release really simplifies the interface and gives it a performance boost as well. The update will work for all existing units.
Thanks a lot! The system looks really interesting and I think will work well for me.

Re: Welcome to the ECC Forum

Posted: Wed Oct 29, 2014 6:28 pm
by clearwaterbrewer