Transitions between processes
Transitions between processes
I am in the process of an automated build wiht the BCS-460 and an expansion card. My question is relative to exit states. I know you can use and exit condition to transition to the next state. . . but . . . Is it possible to do and exit state from one process, to another process? If not, could it be considered in future upgrades? I'll post pictures of my build progress soon and look for some feedback.
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: Transitions between processes
Yes, look at the spawn & kill process options. When exiting a state in a process, you can start or stop other processes. This is good for chaining process control for end-to-end automation.
Re: Transitions between processes
By the way, I have firmware 3.2
Re: Transitions between processes
I don't have a spawn/ kill processes option. Unless I'm looking in the wrong place
Re: Transitions between processes
You'll need to update your firmware, it was introduced in the latest version 3.3
http://www.embeddedcontrolconcepts.com/ ... g_Firmware
http://www.embeddedcontrolconcepts.com/ ... g_Firmware
Move, copy, clear proc/states: http://manipulator.from-ca.com/
Perform coeff. mods: http://calculator.from-ca.com/
HMI latest ver: http://bbrally.altervista.org/guibeta/i ... r=01042020
Perform coeff. mods: http://calculator.from-ca.com/
HMI latest ver: http://bbrally.altervista.org/guibeta/i ... r=01042020