I am looking for a few examples on programing the BCS.
Thank you
BCS programing
-
- Site Admin
- Posts: 1726
- Joined: Sun Jul 18, 2010 7:51 am
- Bot?: No
- Location: Huntington Beach, CA
- Contact:
Re: BCS programing
You're going to have to be more specific.
You may want to read through the wiki. Start here: http://wiki.embeddedcc.com/index.php/Ma ... am_the_BCS
You may want to read through the wiki. Start here: http://wiki.embeddedcc.com/index.php/Ma ... am_the_BCS
-
- Posts: 42
- Joined: Fri Nov 11, 2011 2:34 am
- Bot?: No
- Location: Puerto Rico
Re: BCS programing
I am playing with the programing of the new firmware. I want to jump from 1 proces to another one. but my logic dont work. example I took proces 0 call it Mash, I proragm a timer 0 to cunt for 2 minutes and jump to state 7. then on state 7 I click on Stopp proces 0 and start on proces 7. The alar goes wel but it dont jump. On proces 7 state 0 I program a counter with no exit.
any advice
any advice
-
- Posts: 42
- Joined: Fri Nov 11, 2011 2:34 am
- Bot?: No
- Location: Puerto Rico
Re: BCS programing
ok I activate several out direct on the stage I want to jump. And I saw them go on, but the stage per se dont go green on my screen so I dont know at what stage I am on? unless I see the outs and use my programing logic
ChuckP
ChuckP